12
Lights/Display
Delay
The Delay option can be used to automatically start
the cycle at a later time to reduce daytime heat
buildup in the home or to take advantage of reduced
energy costs if available in your area. This option is
also useful for conserving hot water at times of high
household usage (showers, laundry).
To set up a Delay:
1. Select the appropriate cycle and options for the
load. Close the door.
2. Press the
Delay pad or button until the desired
amount of delay time is selected.
3. The
Delay indicator and the count down display
(select models) will flash until the START/Cancel
pad or START button is pressed.
4. As soon as the
START/Cancel pad or START
button is pressed, the flashing will stop and the
delay time will begin counting down. The Delay
indicator will remain lit until the delay time has
counted down.
5. The cycle will automatically st
ar
t as soon as the
delay time expires.
Note
• If 30 seconds elapse between setting the cycle
and options and pressing the
START/Cancel pad
or START button, the dishwasher will turn off.
To cancel a Delay:
When the delay is counting down, press the Delay
pad or button again. The indicator light will go out and
the cycle will start or resume immediately.
To cancel a Delay and the cycle:
(All touchpad control models)
• Press START/Cancel once to drain and turn off the
dishwasher.
Or
•
Press
S
TART/Cancel
twice to turn dishwasher off
without draining.
To cancel a Delay and the cycle:
(Cycle selector knob models)
• Turn the cycle knob to Dr
ain/OFF
. T
he dishwasher
will drain, then turn off.
Or
• Turn the cycle knob to Drain/OFF, press the START
button once. The dishwasher will turn off without
draining.
Cont.
CYCLES, OPTIONS AND LIGHTS
To Next Page
Loading...
Need help?
General
