EasyManua.ls Logo

Jenn-Air JES8850AAS - User Manual

Jenn-Air JES8850AAS
55 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
JES8750AAB/W
JES8850AAB/Q/S/W
JES8850ACB/S/W
JES9750AAB/S/W
JES9750ACB/W
JES9800AAB/Q/S/W
JES9800ACB/S/W
JES9860AAB/S/W
JES9860ACB/S/W
16025927
February 2005
©2005 Maytag Services
Electric
Slide-In
Range
This Base Manual covers general information
Refer to individual Technical Sheet
for information on specific models
This manual includes, but is
not limited to the following:
Service
This manual is to be used by qualified appliance
technicians only. Maytag does not assume any
responsibility for property damage or personal
injury for improper service procedures done by
an unqualified person.

Table of Contents

Questions and Answers

  • M
    Maria ClarkeAug 16, 2025
    What to do if my Jenn-Air Ranges oven is not operating?
    • M
      Marvin BarryAug 16, 2025
      If your Jenn-Air Ranges oven isn't operating, it could be due to a few reasons. First, there might be a programming error; try switching the circuit breaker off for five minutes and then try the oven again. Second, check for a power outage by verifying power is present at the unit and ensuring the circuit breaker hasn't tripped. Also, check the household fuse, replace if needed, being careful not to exceed fuse capacity. Finally, the unit may be in Sabbath mode; refer to your Use & Care manual to remove it from Sabbath mode.
  • D
    Donna NewmanAug 18, 2025
    Why are the clock and timer not working on my Jenn-Air Ranges?
    • M
      Manuel CollinsAug 19, 2025
      If the clock and timer on your Jenn-Air Ranges are not working, it might be due to a power outage. Verify that power is present at the unit and that the circuit breaker is not tripped. Another cause could be a locked electronic control. Replace the household fuse, being careful not to exceed its capacity. Refer to your Use and Care manual to unlock the electronic control.
  • A
    Abigail RodgersAug 22, 2025
    What to do if the self-clean cycle is not working on my Jenn-Air Ranges?
    • C
      Catherine BarberAug 22, 2025
      If the self-clean cycle on your Jenn-Air Ranges isn't working, it could be due to a programming error. Try turning off the circuit breaker for five minutes and then try the oven again. Also, verify that the door lock energizes and engages properly.
  • M
    Melissa WellsAug 25, 2025
    Why won't the oven door unlock on my Jenn-Air Ranges?
    • J
      Jennifer AguilarAug 26, 2025
      If the oven door on your Jenn-Air Ranges will not unlock, it may be because the oven is running a self-cleaning cycle; allow the cycle to complete. Alternatively, the oven may still be too hot. It will not unlock until it has cooled to a safe temperature. Do not force the door open, as this will void the warranty.
  • R
    Ryan ChangAug 28, 2025
    How to fix a Jenn-Air Ranges with no bake element operation?
    • M
      meltonjessicaAug 28, 2025
      If the bake element in your Jenn-Air Ranges is not working, it could be due to a loose or broken wire connection. Check the element for continuity and replace it if it has failed. Another possibility is an open bake relay; verify that all connections are clean and tight and replace any broken wires. Also, verify 240 VAC is present at the bake element.
  • M
    Miss Danielle OrtizAug 31, 2025
    How to troubleshoot a Jenn-Air Ranges with no broil element operation?
    • S
      Sarah ColonAug 31, 2025
      If the broil element in your Jenn-Air Ranges is not working, it could be due to a loose or broken wire connection. Check the element for continuity and replace it if it has failed. Another possible cause is an open broil relay. Verify that all connections are clean and tight, and replace any broken wires. Also, verify that 240 VAC is present at the broil element.
  • M
    Michael StanleySep 3, 2025
    Why doesn’t the surface element heat on my Jenn-Air Ranges?
    • S
      Sherri JonesSep 3, 2025
      If the surface element on your Jenn-Air Ranges doesn’t heat, it could be due to a loose or broken wire connection. Check the element for continuity and replace it if it has failed. Another possibility is a failed infinite switch; verify that all connections are clean and tight, and replace any broken wiring. Also, check the infinite switch and replace it if it has failed.
  • B
    brycepriceSep 5, 2025
    What to do if the oven light does not operate on my Jenn-Air Ranges?
    • G
      garciajessicaSep 5, 2025
      If the oven light in your Jenn-Air Ranges does not operate, it could be due to failed wiring. Check the lamp and replace it if necessary. Another cause might be a failed light socket; check for broken, loose, or dirty connections. Also, check the light socket for continuity.
  • C
    Charles MclaughlinSep 9, 2025
    Why does my Jenn-Air Ranges oven smoke or have an odor during the first few uses?
    • K
      Kelsey McclainSep 9, 2025
      Minor smoking or odor is normal the first few times you use your Jenn-Air Ranges oven. Ensure the area is well-ventilated and perform a self-clean cycle.
  • J
    James SalazarSep 12, 2025
    Why is the surface element or warming zone cycling frequently on my Jenn-Air Ranges?
    • K
      Katherine SosaSep 12, 2025
      Frequent cycling of the surface element or warming zone on your Jenn-Air Ranges is normal. The element cycles to maintain proper heat and prevent damage to the smoothtop.

Jenn-Air JES8850AAS Specifications

General IconGeneral
BrandJenn-Air
Model NumberJES8850AAS
Product TypeRange
TypeSlide-In
Fuel TypeElectric
Number of Burners5
Convection OvenYes
Self-CleaningYes
ColorStainless Steel
Cooktop SurfaceGlass
Width29 7/8 in

Related product manuals