Jenn-Air JES8750AAB - User Manual

Jenn-Air JES8750AAB

55 pages

Save Page as PDF

To Next Page

To Next Page

Loading...

JES8750AAB/W

JES8850AAB/Q/S/W

JES8850ACB/S/W

JES9750AAB/S/W

JES9750ACB/W

JES9800AAB/Q/S/W

JES9800ACB/S/W

JES9860AAB/S/W

JES9860ACB/S/W

16025927

February 2005

©2005 Maytag Services

Electric

Slide-In

Range

This Base Manual covers general information

Refer to individual Technical Sheet

for information on specific models

This manual includes, but is

not limited to the following:

Service

This manual is to be used by qualified appliance

technicians only. Maytag does not assume any

responsibility for property damage or personal

injury for improper service procedures done by

an unqualified person.

Table of Contents

Questions and Answers

E
ewardAug 15, 2025
What to do if my Jenn-Air Ranges oven is not operating?
- A
  Anna LongAug 15, 2025
  If your Jenn-Air Ranges oven isn't operating, it could be due to a few reasons. First, there might be a programming error; try switching the circuit breaker off for five minutes and then try the oven again. Second, check for a power outage by verifying power is present at the unit and ensuring the circuit breaker hasn't tripped. Also, check the household fuse, replace if needed, being careful not to exceed fuse capacity. Finally, the unit may be in Sabbath mode; refer to your Use & Care manual to remove it from Sabbath mode.
G
greenanthonyAug 18, 2025
Why are the clock and timer not working on my Jenn-Air Ranges?
- P
  Patricia LewisAug 19, 2025
  If the clock and timer on your Jenn-Air Ranges are not working, it might be due to a power outage. Verify that power is present at the unit and that the circuit breaker is not tripped. Another cause could be a locked electronic control. Replace the household fuse, being careful not to exceed its capacity. Refer to your Use and Care manual to unlock the electronic control.
J
Jaime JonesAug 21, 2025
What to do if the self-clean cycle is not working on my Jenn-Air Ranges?
- J
  Julie JohnsonAug 22, 2025
  If the self-clean cycle on your Jenn-Air Ranges isn't working, it could be due to a programming error. Try turning off the circuit breaker for five minutes and then try the oven again. Also, verify that the door lock energizes and engages properly.
R
rachel71Aug 25, 2025
Why won't the oven door unlock on my Jenn-Air Ranges?
- R
  ryanwrightAug 26, 2025
  If the oven door on your Jenn-Air Ranges will not unlock, it may be because the oven is running a self-cleaning cycle; allow the cycle to complete. Alternatively, the oven may still be too hot. It will not unlock until it has cooled to a safe temperature. Do not force the door open, as this will void the warranty.
S
Samantha MoralesAug 28, 2025
How to fix a Jenn-Air Ranges with no bake element operation?
- C
  Courtney AndrewsAug 28, 2025
  If the bake element in your Jenn-Air Ranges is not working, it could be due to a loose or broken wire connection. Check the element for continuity and replace it if it has failed. Another possibility is an open bake relay; verify that all connections are clean and tight and replace any broken wires. Also, verify 240 VAC is present at the bake element.
A
Andrew BergAug 31, 2025
How to troubleshoot a Jenn-Air Ranges with no broil element operation?
- B
  basslisaAug 31, 2025
  If the broil element in your Jenn-Air Ranges is not working, it could be due to a loose or broken wire connection. Check the element for continuity and replace it if it has failed. Another possible cause is an open broil relay. Verify that all connections are clean and tight, and replace any broken wires. Also, verify that 240 VAC is present at the broil element.
D
Donald RobertsSep 2, 2025
Why doesn’t the surface element heat on my Jenn-Air Ranges?
- K
  Kristin StoneSep 2, 2025
  If the surface element on your Jenn-Air Ranges doesn’t heat, it could be due to a loose or broken wire connection. Check the element for continuity and replace it if it has failed. Another possibility is a failed infinite switch; verify that all connections are clean and tight, and replace any broken wiring. Also, check the infinite switch and replace it if it has failed.
J
Joseph BrownSep 5, 2025
What to do if the oven light does not operate on my Jenn-Air Ranges?
- E
  Emily CarsonSep 5, 2025
  If the oven light in your Jenn-Air Ranges does not operate, it could be due to failed wiring. Check the lamp and replace it if necessary. Another cause might be a failed light socket; check for broken, loose, or dirty connections. Also, check the light socket for continuity.
S
Shawn EdwardsSep 8, 2025
Why does my Jenn-Air Ranges oven smoke or have an odor during the first few uses?
- K
  Kimberly BrewerSep 8, 2025
  Minor smoking or odor is normal the first few times you use your Jenn-Air Ranges oven. Ensure the area is well-ventilated and perform a self-clean cycle.
T
todd87Sep 12, 2025
Why is the surface element or warming zone cycling frequently on my Jenn-Air Ranges?
- B
  Billy TuckerSep 12, 2025
  Frequent cycling of the surface element or warming zone on your Jenn-Air Ranges is normal. The element cycles to maintain proper heat and prevent damage to the smoothtop.

Jenn-Air JES8750AAB Specifications

General

Brand	Jenn-Air
Model Number	JES8750AAB
Product Type	Range
Fuel Type	Electric
Color	Black
Cooktop Surface	Glass
Number of Burners	5
Oven Capacity	5.3 cu. ft.
Convection Cooking	Yes
Self-Cleaning	Yes
Warming Zone	Yes
Voltage	240V
Control Type	Touch Control
Width	30 inches

Related product manuals

Jenn-Air JES8750

Jenn-Air JES8750BAF16

Preview: Jenn-Air JES8750BA Series

Jenn-Air JES8750BA Series

Jenn-Air JES8850ACS

Jenn-Air JES8850AAQ

Jenn-Air JES8850AAS

Jenn-Air JES8850AAB

Preview: Jenn-Air JES8850CAF00

Jenn-Air JES8850CAF00

Jenn-Air JES8850CAS02

Jenn-Air JES9800ACS

Jenn-Air JES9860AAB

Jenn-Air JES1450CDS0