8101P580-60
(04-04-00)
INSTALLATION
MANUAL
CONVERTIBLE GAS GRILL
COOKTOP SERIES
JGD8130 & JGD8345
403 WEST FOURTH STREET, NORTH · NEWTON, IA 50208
29² + 1/16²
73.66 cm
DIMENSIONS SHOWN IN BOTH INCHES AND CENTIMETERS
*Blower may be rotated for horizontal or vertical direction by loosening nuts around blower inlet. Accessible inside ventilation
chamber.
S NOTICE TO INSTALLER: Leave these instructions with the appliance.
S NOTICE TO CONSUMER: Retain these instructions for future reference.
INSTRUCTIONS TO INSTALLER
S Dimension “A” - Provide 2² min. (5.08 cm) cabinet clearance to motor for cooling purpose.
S Note - Where possible, 6² (15.24 cm) is recommended for motor/blower service.
S Side Clearance - Grills installed near a side wall must allow a minimum clearance of 8².
S Access must be provided to remove and empty grease container(s).
TIE DOWN BOLT
ON EACH END
BLOWER CAN BE
SWIVELED 90_
GREASE
CONTAINER
WIRING BOX COVER
APPLIANCE PRESSURE
REGULATOR
21² + 1/16²
53.34 cm
7
9/16²
19.21 cm
1
7/8²
Min.
4.76 cm
13²
33.02 cm
9
3/8²
23.81 cm
15/16²
Min.
Clearance
2.38 cm
SELECT APPROPRIATE
DUCT CUT OUT (SEE
DUCTING INSTALLA-
TION INSTRUCTIONS).
43 1/4² +
1/16²
109.86 cm
21² + 1/16²
53.34 cm
7
9/16²
19.21 cm
1
7/8²
Min.
4.76 cm
13²
33.02 cm
9
3/8²
23.81 cm
15/16²
Min.
Clearance
2.38 cm
SELECT APPROPRIATE
DUCT CUT OUT (SEE
DUCTING INSTALLA-
TION INSTRUCTIONS).
TIE DOWN BOLT
ON EACH END
BLOWER CAN BE
SWIVELED 90_
GREASE
CONTAINER
WIRING BOX COVER
APPLIANCE PRESSURE
REGULATOR
To Next Page
Need help?
General
