Jenn-Air SEG196-C series User Manual

Details on natural gas or LPG fuel.

Details on voltage, amperage, and wire requirements.

Physical measurements of the appliance.

Guidance for connecting the unit electrically.

Instructions for unpacking the appliance from its carton.

Guidance on choosing a suitable location for the range.

Information on mounting options for free-standing or slide-in installation.

Details on the cutout required for a free-standing installation.

Instructions on measuring for slide-in cutout based on overhang.

Specifics for creating the slide-in cutout, including rear dimensions.

Guidelines and clearances for cabinets installed above the range.

Instructions for measuring and marking vent cutouts on the floor.

Details on creating floor vent cutouts, considering joists.

Guidance for cutting openings in the wall for venting.

Procedure for installing the blower unit prior to range installation.

Instructions for installing the gas shutoff valve.

General electrical installation guidelines and power requirements.

Steps for connecting the three-conductor electrical wire.

Steps for connecting the four-conductor electrical wire.

Procedures for pressure testing the gas supply system.

Instructions for converting the appliance from natural gas to LP gas.

Adjusting air shutters for proper burner flame appearance.

Adjusting low flame settings for optimal cooking performance.

Information on installing optional accessories like backsplashes.

Guidance on positioning the range after installation.

Procedure for installing the anti-tip bracket for safety.

Instructions for leveling the range for optimal performance.

Connecting the blower power cord to the range power cord.

Attaching the flexible duct to the blower and range.

Steps to verify the proper functioning of the appliance.

Procedure for installing the lower access door.

Important information regarding servicing the appliance.