- 08 -
Connect via QR Code
1. Set up WiFi for the camera.
1) Make sure your phone is connected to the WiFi in your house.
Note: The camera can only connect to a 2.4 GHZ WiFi signal. It does not
support using a 5 GHZ signal.
2) Connect the power adapter, then press and hold on to the reset button for
8-10 seconds to restore the camera.
For a successful connection, bring both your mobile phone and your camera
close to your router when connecting for the first time (max distance of 5
meters/16 feet).
Support : support@jennov.com
To Next Page
Loading...
Need help?
General
