E-8
SNOOZE FUNCTION
When the alarm sounds, tap the SNOOZE BUTTON (#5) to temporarily turn off the
alarm and activate the snooze function, the alarm will stop and sound again 9
minutes later. If you tap the SNOOZE (#5) again, the alarm will temporarily turn off
again and sound again in 9 minutes and so on. The alarm sound will turn off after
one hour.
NOTES :
•
To temporarily silence the alarm, press the SNOOZE BUTTON (#5). The alarm will
sound again when the snooze period (9 minutes) expires.
•
The corresponding Alarm 1 or Alarm 2 indicator (alarm or radio) flashes on the
display during the snooze period.
•
To cancel the snooze period and the alarm, press / MODE BUTTON (#9).
RADIO OPERATION
Listening to the radio
1. Tap the
/ MODE BUTTON (#9
) repeatedly to turn the unit on and select either
AM or FM radio mode. The frequency of the station will show on the display.
2. Press and hold the
MIN / BUTTON
(#3) OR
HOUR / BUTTON
(#2) to
search for the next / previous available station.
3. If the reception is poor, try Manual Tuning to fine-tune the station. Tap the
MIN /
BUTTON
(#3) OR
HOUR / BUTTON
(#2) briefly to manually tune through the
frequency band.
4. Adjust the
/ BUTTON
(#8) and
/ BUTTON
(#7) to obtain the desired
sound level.
5. When you have finished listening, press and hold / MODE BUTTON (#9
)
to
turn the radio off.
NOTES:
•
When in radio mode, the display will automatically switch back to showing the
time after a few seconds.
•
When listening to the radio, you can check the frequency of the station you are
listening by tapping the MIN / BUTTON (#3) OR HOUR / BUTTON (#2).
The unit will automatically change back to the time after a few seconds.
Setting the Radio Station Presets
The unit allows you to store up to 30 FM stations and 20 AM stations for easy recall
at any time.
1. Press the / MODE BUTTON (#9
)
repeatedly to turn on the unit and
select either
AM or FM radio mode.
2. Tune to the radio station you want to store in memory.
3. Press and hold the / MEM / M + BUTTON (#1). The preset channel number
“P01” will be flashing on the display.
4. To change the preset channel number location, press the MIN / BUTTON
(#3)
OR
HOUR / BUTTON
(#2)
to step through the preset locations.
5. To confirm the preset location, press / MEM / M + BUTTON (#1).
6. To store another station presets, repeat steps 2-5 above.
RECALLING A PRESET STATION
In AM or FM mode, tap the / MEM / M + BUTTON (#1) repeatedly to select the
preset channel.
To Next Page
Loading...
