Jensen Eagle 1500 User Manual

Eagle 1500 FAQ
version 1.1 - Desember 2015 - © JensenScandinavia AS
What is Eagle 1500?
How do I setup the Eagle 1500?
How do I setup the Eagle 1500 using WPS?
How do I change the network name?
Where should I place the Eagle 1500?
What can I use the network port for?
How do I reset the Eagle 1500?
My Eagle 1500 will not connect to my network
How to check the connection status
LED and connections on the Eagle 1500
How do I upgrade the firmware?
Where can I get more help?
......................................................2
.....................................3
..................5
.............................6
............................7
..............................7
......................................8
...............9
...............................10
......................11
. ....................................12
...........................................13
Page index

Jensen Eagle 1500 Specifications

General

Brand	Jensen
Model	Eagle 1500
Category	Repeater
Language	English

Summary

How do I setup the Eagle 1500?

Connect to Power and Computer

Connect the Eagle 1500 to a power outlet and your computer via network cable.

Access Setup Interface

Open a web browser and navigate to http://jensen.setup or alternative IP address.

Select Wireless Network

Choose the desired wireless network from the displayed list of available SSIDs.

Confirm Connection and Enter Password

Confirm connection to the access point and enter the wireless network password.

Save Settings and Reboot

Check Connection Status

How do I setup the Eagle 1500 using WPS?

Enable WPS and Initiate Connection

Monitor Connection Status

How do I change the network name?

How do I reset the Eagle 1500?

Perform Factory Reset

My Eagle 1500 will not connect to my network?

Check Placement and Signal

Ensure the Eagle 1500 is within range of the wireless router and not near interference.

Verify Network and Password

Confirm the correct wireless network name (SSID) and password/encryption key are used.

How to check the connection status

LED and connections on the Eagle 1500

How do I upgrade the firmware?