7
Fig 4
Connector Housing:
Place an upper gasket (S, Fig 5) and
attach bag housing (F) with hex cap
screws, washers and nuts.
Fig 5
Refere to Fig 6 for correct assembly.
Fig 6
Support bracket:
Attach support bracket (V, Fig 7) to the
base with 2 hex head screws (W) and
washers.
Fig 7
Insert bag hanger bracket (T) and
attach with 2 hex head screws (U) and
washers.
Cone Assemby:
Mount the cone support bracket (I, Fig
8) to the housing with 4 hex cap
screws (J) and nuts.
Mount the cone (K) from beneath with
hex cap screw (H), washer and nut.
Fig 8
Collector bag:
Fold the plastic bag over the top of the
snap ring (E, Fig 9).
Fig 9
Insert the snap ring (E) of the collector
bag into the bottom of the housing at
an angle. Pull down until it engages in
the grove (F, Fig 10)
To Next Page
