14
10.2 Performance problems
Symptom Possible Cause Correction
Poor performance; lack
of suction.
Hose improperly secured at dust
origination point.
Inspect and remedy.
Inlet port is open. Cap unused inlet ports.
Collection bag is full. Empty bag (check sight window).
Collection drum not sealed properly. Inspect drum for leaks, make sure lid is
tight.
Canister filter is dirty. Clean filter.
Wood has excess moisture content. Use lumber with lower moisture content.
Obstruction in dust hose or inlet port. Inspect and clear obstruction.
Dust hose too long. Move collector closer to dust source.
Excess dust or large
chips backing up into
canister filter.
Collection drum not sealed properly. Inspect drum for leaks, make sure lid is
tight.
Collection bag full. Empty bag (check sight window).
11.0 Replacement Parts
Replacement parts are listed on the following pages. To order parts or reach our service department, call 1-800-
274-6848 Monday through Friday, 8:00 a.m. to 5:00 p.m. CST. Having the Model Number and Serial Number of
your machine available when you call will allow us to serve you quickly and accurately.
To Next Page
Loading...
Need help?
General
