What to do if my Jet XACTA Deluxe stops or will not start?
If your Jet Saw stops or won't start, try the following: First, allow the motor to cool down and reset it by pushing the off switch. Then, check all plug connections to ensure they are secure. After that, replace the fuse or reset the circuit breaker. As a last resort, consider replacing the cord.
Why is material kicked back from the blade on my Jet Saw?
If material is kicked back from the blade of your Jet Saw, ensure the rip fence is aligned with the miter slot and the splitter is aligned with the blade. Install and use the rip fence and splitter (with guard). Replace the blade or sharpen the anti-kick back plates. Push material completely past the blade before releasing.
How to improve unsatisfactory cuts with my Jet XACTA Deluxe Saw?
If your Jet Saw makes unsatisfactory cuts, try these steps: First, sharpen or replace the blade. If that doesn't work, turn the blade around. Then, remove and clean the blade. Ensure you are using the correct type of blade. Finally, clean the table.
Why does my Jet Saw vibrate excessively?
If your Jet Saw vibrates excessively, try these solutions: Reposition it on a flat, level surface. If the vibration persists, replace the saw blade, V-belts, or pulley. Also, check and adjust the motor, and ensure all hardware is tightened.
How to fix inaccurate cuts (45° or 90°) on my Jet XACTA Deluxe?
If your Jet Saw does not make accurate 45° or 90° cuts, check the blade with a square and adjust the stops and pointer. You may also need to adjust the miter gauge.
What to do if material binds the blade when ripping with my Jet XACTA Deluxe Saw?
If the material binds the blade when ripping with your Jet Saw, check and adjust the fence. Try selecting another piece of wood or reducing the feed rate. Also, ensure the splitter is aligned with the blade.
How to fix a Jet XACTA Deluxe blade that doesn't raise or tilt freely?
If the blade on your Jet Saw does not raise or tilt freely, clean and re-grease the mechanism.
Covers warranty terms, exclusions, service procedures, and contact info.
Details essential safety rules for machine operation and handling.
Specific safety instructions for using the table saw and safety notice definitions.
Steps to attach extension wings and install/replace the saw blade.
Steps for switch mounting and critical electrical connection safety.
Table of problems, possible causes, and solutions for saw operation.
Electrical schematics for 1-phase and 3-phase motor configurations.
To Next Page
General
