Jetmaster Open Wood Fire User Manual

Flues or chimneys should be cleaned at least once a year for best results.
 Before cleaning a Jetmaster fire chimney and flue it is essential to remove the fire's damper blade.
 Remove damper lever friction bar by unscrewing the two adjustment nuts on the friction bar (diagram 3). These
nuts are also used for tightening or loosening damper level control.
 Push right hand side of damper upwards to relieve locating bracket pin. Slide damper fractionally to the right to
remove damper from left hand locating pin. Remove damper.
 Clean chimney and flue upwards through smoke ducts, vacuum clean.
 Reverse the above to reinstall damper blade.
 It is also essential to ensure the cowl is cleaned at the same time as the flue.
 Use high temperature black paint for touch-up purposes when required. Ensure all surfaces are cleaned and
either wire brushed or rubbed over with a scotchbrite before applying paint. Contact The Fireplace Ltd for
additional paint if needed.
Jetmaster Open Wood Fire
Lighting and maintaining an efficient Jetmaster
and Chimney/Flue cleaning
Exclusive New Zealand Distributor
The Fireplace Ltd
12 Tawari Street, Mt Eden
Auckland 1024, New Zealand
09 623 6990 | thereplace.co.nz

Jetmaster Open Wood Fire Specifications

General

Brand	Jetmaster
Model	Open Wood Fire
Category	Indoor Fireplace
Language	English