12
ADJUSTING THE POSITION OF THE LCD DISPLAY
To adjust the position of the LCD Display, loosen the bolts that connect the
LCD Display to the Handlebars using the provided Allen key. Adjust the angle
of the LCD Display to your preference, then tighten the bolts so the LCD
Display is secure.
SAFE RIDING
Before each ride, check whether all the bolts are tight, the battery power is full,
the charging port is covered, the tire pressure is sufcient, all wires are plugged
in, and the brake system works correctly. Avoid direct contact with water.
Bolts
ATTACHING THE SADDLE
• Slide the Saddle Post into the Saddle Tube.
• Align the Saddle with the Frame to make sure it is straight.
• Tighten the Saddle Clamping Lever.
• The height of the Saddle should not be pulled higher than the safety tick
marks on the Saddle Post.
To Next Page
Loading...
Need help?
General
