8
1.4 Securing the Bell
1. LOOSEN BUT DO NOT REMOVE THE SCREW ON THE BELL CLAMP BY TURNING IT COUNTERCLOCKWISE FOR
1 2 ROTATIONS WITH THE PHILLIPSHEAD SCREWDRIVER TIP 8 OF THE MULTITOOL.
2. ROTATE THE BELL AROUND THE HANDLEBAR UNTIL IT IS IN A PLACE THAT CAN EASILY BE REACHED BY
THE RIDER'S LEFTHAND THUMB WHILE HOLDING ONTO THE HANDLEBAR.
3. WHILE HOLDING THE BELL IN THAT POSITION, TIGHTEN THE CLAMP BY TURNING THE SCREW
CLOCKWISE WITH THE SCREWDRIVER.
PHILLIPSHEAD SCREWDRIVER 8
BELL
SCREW
To Next Page
Loading...
