Care & Maintenance
CLEANING THE JLR X
• Carefully wipe with a damp cloth, then dry with a dry cloth.
• Do not use water to clean the JLR X, as the electrical and electronic systems may get wet, resulting in personal injury or
malfunction of the JLR X.
BATTERY
• Keep away from fire and excessive heat.
• Avoid intense physical impact and / or severe vibration.
• Protect from water or moisture.
• Do not disassemble.
• If there are any issues with the battery, please contact Jetson Customer Care. We’d love to help!
STORAGE
• Remove batteries before storing.
• Cover to protect against dust.
• Store indoors, in a dry place and at a suitable temperature.
CHAIN ADJUSTMENT
The chain must remain on the sprockets. If the chain comes o the sprockets, the coaster brake will not operate.
ADJUSTMENT:
• The chain must be at the correct tightness.
• If too tight, the bicycle will be diicult to pedal.
• If too loose, the chain can come o the sprockets.
When the chain (C) is at the correct tightness, you can rotate the crank freely and you can pull it no more than one-half inch
(A) away from a straightedge (B) as shown.
Adjust the tightness of the chain as follows:
• Loosen the axle nuts of the rear wheel.
• Move the rear wheel forward or backward as necessary.
NOTE: Make sure the rear wheel is in the center of the bicycle frame.
• Hold the wheel in this position and tighten the axle nuts.
C
B
A
WARNING:
Do not attempt chain repairs. If there is a problem with the chain, have a
bicycle service shop make any repairs.
To Next Page
Loading...
Need help?
General
