2.3 When & How to Recalibrate
SOMETIMES THE INTERNAL BALANCE MECHANISMS ON A BOARD NEEDS TO BE RESET, OR "RECALIBRATED."
IMPORTANT: RECALIBRATE YOUR BOARD STRAIGHT OUT OF THE BOX. THEN, RECALIBRATE AS NECESSARY. SIGNS YOUR
BOARD MIGHT NEED RECALIBRATING INCLUDE CONSTANT BEEPING AND/OR SPINNING OF THE WHEELS.
IMPORTANT: DO NOT LEAN OR APPLY ANY WEIGHT ON THE BOARD DURING THE RECALIBRATION PROCESS.
1. PLACE THE BOARD ON A FLAT SURFACE AND UNFOLD
3
⁄4 WAY TO POWER IT ON. LEAVE THE BACK STANDING PLATFORM
TILTED UP AT A 450 ANGLE AWAY FROM THE RESTING SURFACE.
2. PLACE THE RECALIBRATION SUPPORT PIECE UNDER THE FRONT STANDING PLATFORM TO STABILIZE THE PLATFORM AND
LEVEL IT PARALLEL TO THE GROUND.
IMPORTANT: ENSURE THAT THE FRONT STANDING PLATFORM IS NOT TILTED OR AT AN ANGLE. ADJUST THE SUPPORT PIECE
AS NECESSARY TO ENSURE THAT THE PLATFORM IS LEVEL.
3. WHILE PRESSING AND HOLDING THE ACCELERATOR BUTTON, LOWER THE BACK STANDING PLATFORM ALL THE WAY DOWN
UNTIL THE ACCELERATOR BUTTON ILLUMINATES IN GREEN AND YOU HEAR A SERIES OF 5 BEEPS. (HOLD ABOUT 3 SECONDS.)
4. AFTER 5 BEEPS HAVE SOUNDED, RELEASE THE ACCELERATOR BUTTON. RECALIBRATION IS NOW COMPLETE.
NOTE: IT MAY TAKE A FEW RECALIBRATION ATTEMPTS TO FULLY RESET THE BOARD'S INTERNAL BALANCE MECHANISMS.
ACCELERATOR BUTTON
BACK STANDING PLATFORM
FRONT STANDING PLATFORM
RECALIBRATION
SUPPORT PIECE
3
3
2
1
To Next Page
Loading...