© 2011 Jetta Corporation. All rights reserved. REV 06/2011
800-288-7771
12
owner’s manual
The bath should be lled 2” over the jets BEFORE turning the pump on.
Harmony Falls: In addition to the 3-level pump pressure control, each
individual body jet may be adjusted manually, To increase the jet pres-
sure, grasp the outer ring of the jet and turn clockwise, to reduce jet
pressure turn the outer ring counter-clockwise.
Sanctuary Falls: In addition to the electronic variable speed pump, each
individual body jet may be adjusted manually. To increase the jet pres-
sure, grasp the outer ring of the jet and turn clockwise, to reduce jet
pressure turn the outer ring counter-clockwise
To adjust the individual body jet direction, use your nger to
position the jet nozzle to the desired location.
To remove the individual body jet, grasp the outer ring of the jet
and turn counter clock-wise until the jet clicks – then pull jet out.
To install an individual body jet, insert the jet into the jet housing (do
not force the jet) and turn clockwise until the jet clicks – will pass a
point of resistance.
When bathing is complete, the pump must be turned off and the bath
emptied. Adjust the inner nozzle portion of the all the body jets in a downward position while draining the bath,
to allow the bath to drain properly.
Harmony and Sanctuary Falls
To Next Page
Loading...