Jetta Water Dance Baths - Installation Instructions

© 2011 Jetta Corporation. All rights reserved. REV 06/2011
800-288-7771
8
owner’s manual
installation instructions
Use union connections only for the pump. Do not overtighten. Make sure the O-rings on the pump are in place.
Hand tighten pump ttings. Do not use a wrench, channel locks, or pipe dope (teon paste).
Pump must be located between 1/2” to 1 1/2” above suction tting. Make sure suction line will drain from pump to
bath. A minimum access panel of 14” x 10” must be provided in case the pump or air blower needs to be serviced
at a later date.
The electronic controls must be located on or near bath, with access available.
Faucets may be installed through the wall or mounted on the bath. Insert drain and overow to waste line. After
installation, ll the bath and let stand 3 - 4 hours (operating it for at least 30 minutes) to double check that it is still
water tight. When installation and testing have been completed, frame around your bath and cover as appropriate
with solid surface, tile, marble, etc.
ACCESS