Due to the low efficiency and high processor load caused by this protocol, please do not use Port 30003
unless really necessary.
A better way of getting about the same data is the deltadb web page.
NTP Stratum 1 Normal
The Radarcape can be used as NTP source for correct time setting. For example, Planplotter requires
such for its own Multilateration.
Software Packages
Starting with November 2013, the release strategy will be Linux installer packages, which include the
Linux software as well as the FPGA firmware.
Release_140412.08.49
New Features:
● none
Changes:
● New FR24 feeder
● Some performance increase with Port 30003 data output
● The flight routes link parser was changed to handle the new structure of the links
Automatic Installation:
● Go to the Maintenance page of the Radarcape, verify if software version field shows above
version, and simply press Update button.
Please note that that it might not work, as it is not yet tested broadly. Below method will work anyway if
failed, so in case of failure, you may try the manual installation.
Manual Install command:
opkg update -V http://www.modesbeast.com/resources/radarcaped-140412.08.49.opk
Note: For updates, your Radarcape must have an internet connection. Manual update requires copying
the update package to the Radarcape by any means and issuing the opkg install command for the
location of the package.
To Next Page
Loading...