● Radarcape Mode-S/ADS-B receiver
● GPS module Trimble Resolution SMT
● Common case
Power Consumption:
● 5V external supply
● Standard 2.1 mm DC connector (plus inside, minus outside) without GPS, operating:
typical 620mA
● with GPS (including antenna): typical 720mA
Case:
● Length approximately 92 mm (110 mm with antenna connector)
● Width approximately 80 mm
● Height approximately 45 mm
● Weight approximately 0.233 kg
Linux Distribution
The Radarcape operates with Angstrom Embedded Linux, it is using the pure root file system, not a
Cloud9 system. Due to that, you may not see internal disk drives when plugging the USB. We do not
guarantee stability with other Linux distributions than the one it became delivered, as there were already
some issues.
Beaglebone Board (Rev. A6A)
● AM335x 720MHz ARM Cortex-A8
● 256MB DDR2 RAM
● 3D graphics accelerator (SGX530)
● 2x PRU 32-bit RISC CPUs
● Connectivity
● USB client (mini B receptacle)
● USB host (type A receptacle)
● 100 Base-TX Ethernet
● 2x 46 pin headers (used by Radarcape board)
● microSD card with Angstrom Linux distribution
More Information: www.BeagleBoard.org
Radarcape Board
● FPGA based Mode-S ADS-B receiver
● SMA Mode-S antenna connector
To Next Page
Loading...