JGaurora A3S - Troubleshooting Common Issues

S/N Symptom Diagnoses Solutions
1
Filament󵽱breaks󵽱at󵽱the󵽱feeding󵽱port󵽱of󵽱extruder
Filament󵽱is󵽱about󵽱to󵽱run󵽱out
Filament󵽱is󵽱damaged󵽱arising󵽱from󵽱damp
Filament󵽱is󵽱clogged󵽱in󵽱tube
Replace󵽱the󵽱filament
Keep󵽱the󵽱filament󵽱under󵽱seal󵽱in󵽱cool󵽱and󵽱dry󵽱place
Clean󵽱the󵽱tube
2 Filament󵽱slides󵽱from󵽱the󵽱extruder Filament󵽱is󵽱too󵽱thin Cut󵽱off󵽱the󵽱thin󵽱part
3 Abnormal󵽱temperature Temperature󵽱sensor󵽱failure Replace󵽱with󵽱a󵽱new󵽱temperature󵽱sensor
4 Model󵽱is󵽱not󵽱in󵽱the󵽱right󵽱position Loose󵽱timing󵽱belts Tighten󵽱up󵽱the󵽱bolts󵽱and󵽱timing󵽱belts
5 Warping󵽱found󵽱on󵽱model Bed󵽱is󵽱not󵽱level Level󵽱the󵽱bed
6 Fail󵽱to󵽱generate󵽱G-code󵽱file
Incorrect󵽱settings
Wrong󵽱save󵽱path
Choose󵽱the󵽱correct󵽱machine󵽱type
Select󵽱right󵽱save󵽱path
7 Fail󵽱to󵽱install󵽱software OS󵽱may󵽱not󵽱be󵽱supported Install󵽱the󵽱supported󵽱OS
Troubleshooting
30