Need help?Do you have a question about the JGaurora A5 and is the answer not in the manual?
General| Build Volume | 305 x 305 x 320 mm |
|---|---|
| Layer Resolution | 0.05 - 0.3 mm |
| Print Speed | 10 - 150 mm/s |
| Nozzle Diameter | 0.4 mm |
| Filament Diameter | 1.75 mm |
| Connectivity | USB, SD Card |
| Frame Material | Aluminum |
| Print Technology | FDM (Fused Deposition Modeling) |
| Heated Bed | Yes |
| Bed Temperature | Up to 110°C |
| Nozzle Temperature | Up to 250°C |
| Supported Materials | PLA, ABS |
| Display | LCD |
| Power Supply | 110V / 220V |
Details crucial safety precautions and warnings for operating the 3D printer to prevent injury or damage.
Details how to adjust the printer's input power voltage (115V/230V) to match local standards.
Guides users through the step-by-step process of installing the JGcreat slicing software on their PC.
Provides instructions and a visual guide for performing bed leveling to ensure print adhesion.
Details the procedure for preheating the nozzle and loading filament into the extruder.
Explains the process for reloading filament during or after a print, including precautions.
To Next Page
