Tips:
• It is recommended to clean the dust barrel and filter sponge
after each use; if the dust barrel is full in use, it is recommended to
clean it immediately, or else it will affect the effect.
• Do not scrub the filter sponge violently when cleaning; after
washing the dust barrel assembly, make sure that all the parts are
completely dry before putting it into the main unit.
• After the cumulative use time of the filter sponge reaches
30-50h, it is recommended to replace it to avoid degrading the
performance of the machine.
• If the filter part is forgotten to install and the machine is already
turned on, please turn off the machine immediately and clean
the cyclone cup. (Rotate the left lid of the cyclone cup
counterclockwise to open it and clean the inside of the cyclone
cup. Close the lid by rotating it clockwise after cleaning.)
1. Turn off the machine and
unplug it. Slide the bottom
plate locks up like the
picture shows to unlock the
bottom plate.
2. Remove the bottom plate
and roller brush, and then
clean the roller brush.
Roller brush cleaning
Two bottom plate locks
Locked state Unlocked state
Warning:
The machine must be switched off and unplugged
when you clean the roller brush.
EN
04
1. Turn off the machine and
rotate the aroma container
counterclockwise to remove
it from the machine.
2. Rotate the lid of the
aroma container counter-
clockwise to open it.
3. Remove the aluminium
foil from the aroma capsule.
4. Place the aroma capsule
into the container and close
the lid tightly.
Aroma capsule replacement
Note:
Please clean the aroma container and check the remaining
aroma regularly to ensure that the container rotates smoothly
and the aroma functions effectively.
Instruction of aroma function
To reduce the aroma and slow down the aroma diffusion;
To increase the aroma and accelerate the aroma diffusion;
To minimize the aroma diffusion and prolong the use of
the aroma capsule;
To unlock the aroma container and replace the aroma
capsule;
To Next Page
Loading...
