Jio JioExtender JMB43 - Setup JioExtender6 Agent

3 Press the power button ( ) on the back of the JioExtender6. At rst, the
Status LED will be solid yellow, then it will ash yellow.
4 Once Status LED starts ashing yellow every second, congure your
JioExtender6 to controller mode using JioHome App MyNetwork feature or
its webUI. Refer to the section “Congure your JioExtender6” of this QSG.
5 Wait until the Status LED turns solid green before connecting your
Wi-Fi devices.
4 Setup JioExtender6 Agent
Make sure your JioExtender6 Agent isn’t joined already to an existing
EasyMesh home network. JioExtender6 should be in factory reset state.
Procedure
1. Connect one end of the LAN cable to the LAN port at the back of your
JioExtender6. Connect the other end of the LAN cable to a LAN port of your
JioExtender6 controller.
2. Take the power supply, plug the small end into the power inlet port of
the JioExtender6 and then plug the other end into a nearby power outlet.
3. Press the power button on the back of the JioExtender6. At rst, the
Status LED will be solid yellow and when the device is ready for onboarding,
the yellow light will ash every second. If this is not the case, check the
connections you have made.
4. During EasyMesh onboarding, the Status LED on the JioExtender6 goes
through (one or more of) the following states:
●
Flashing green & yellow (1 second each): EasyMesh onboarding started
and ongoing.
●
Flashing green (3 seconds) & yellow (1 second): EasyMesh onboarding
has failed.
●
Flashing green (1 second) & yellow (3 seconds): No EasyMesh network
was found.
●
Solid Green: Onboarding is successful, JioExtender6 Agent is paired with