To Next PageTo Next Page
Need help?Do you have a question about the JL Audio M800/8-24V and is the answer not in the manual?
General| Channels | 8 |
|---|---|
| Amplifier Class | D |
| Frequency Response | 12 Hz - 22 kHz (+0, -1dB) |
| Input Sensitivity | 200mV - 8V |
| Power Output (2 Ohm) | 100 W RMS x 8 |
| Power Output (Bridged 4 Ohm) | 200 W RMS x 4 |
| Signal-to-Noise Ratio | >104 dB |
| THD+N at Rated Power | <1% |
| Fuse Rating | 40A |
Instructions to record the product's serial number for service or theft records.
Details how to ensure optimal cooling for the amplifier's performance.
Outlines requirements for a safe, dry, and ventilated installation environment.
Warns against drilling hazards and improper wire routing during installation.
Advises upgrading vehicle/vessel ground and power wires for high fuse ratings.
Specifies the acceptable input voltage range for the amplifier's inputs.
Explains how to adjust input sensitivity for optimal clean output.
Explains the three positions (Off, LP, HP) of the filter mode switch.
Describes the filter frequency selection rotary control and its tuning hints.
Details how the switch assigns control of channel pairs to the remote level control.
Warns about load limitations and input requirements when bridging channels.
Describes conditions that cause the amplifier to shut down completely.
Contact information for technical assistance regarding installation or setup.
Lists the required equipment for setting input sensitivity.
Outlines the step-by-step process for adjusting input sensitivity.
Warns against exceeding maximum input sensitivity settings to avoid distortion or damage.
Troubleshooting steps for an amplifier that fails to power on.
Diagnoses and fixes for ticking or popping sounds, often related to shorts.
Addresses issues with fluctuating output, usually due to loose connections.
Instructions for obtaining service and warranty returns for JL Audio products.
