VR600-CSi SPECIFICATIONS:
Woofers: Injection-molded, mica-filled, polypropylene
cone body, 1-inch (25mm) voice coil, flat-profile/
symmetrical-roll spider, butyl rubber surround.
Tweeters: 0.75-inch (19 mm) silk soft dome
tweeter, neodymium magnet, ferrofluid cooled and
damped. Variable mounting system with swivel/
rotation capability.
Crossover Networks: 2-way network with 1st
order low-pass circuit and 2nd order high pass
circuit. Premium Mylar Capacitors and Air-Core
inductors. Adjustable tweeter output level.
Polyswitch tweeter protection
Continuous Power Handling:
60 Watts (RMS Method)
Frequency Response: 59 Hz - 25 KHz (± 3 dB)
Efficiency @ 1W/1m: 89.0 dB
Nominal Impedance: 4 ohms
Included Components and Parts:
• Two VR600-CWi 6-inch (150 mm) woofers
• Two VR075-CT 0.75-inch (19 mm) tweeters
• Two VR600-CSxo 2-Way
Crossover networks
• Two Flush-Mount tweeter fixtures with metal
spring clips.
• Two Surface-Mount tweeter fixtures.
• Two Metal Woofer Grilles and Grille Trays
• Butyl adhesive putty for woofer grilles
• Twelve #8 x 1 1/4-inch (30 mm)
sheet metal screws
• Four #6 x 5/8” (16 mm) sheet metal screws
• Two 1-inch (25 mm) machine screws
• Eight Mounting Clips
• Two 5.2 mm female crimpable connectors
• Two 2.8 mm female crimpable connectors
• Four 2.8 mm male crimpable connectors
• Four black nylon wire ties
GETTING STARTED:
• Turn off the audio system. It is also advisable to
disconnect the negative (-) terminal of your
vehicle’s battery whenever performing
installation work.
• Before cutting, drilling or inserting any screw,
check clearances on both sides of the planned
mounting surface. Also check for any potential
obstacles, such as window tracks and motors,
wiring harnesses, etc. Check both sides of the car,
many cars are not symmetrical!
• Always wear protective eyewear.
To Next Page
