JM POSNER SQ2 - Page 15

15
CHANGING THE BEARING HOUSING - SQ4 TALL
1. TochangetheBearingHousingyouwillneedtousetheHousingWrench(supplied)
2. InsertthehousingWrenchintotheholeinthesideoftheBearingHousing.
3. IMPORTANT:EnsurethatthefountainiscompletelycoolbeforechangingtheBearing
Housingasifitishotthemetalwillhaveexpanded
4. Tounscrewturnanticlockwise.RemovetheBearingHousingandtheHousingGasket.
5. ReplacewithnewHousingGasketandBearingHousingandtightenbyturning
clockwise.PleaseensuretheBearingHousingistightenedfully.