JML circulation enhancer

Questions and Answers

A
Amber WilliamsAug 1, 2025
Why is it difficult to feel stimulation from my JML circulation enhancer?
- D
  Dawn WilsonAug 1, 2025
  If you're finding it hard to feel the stimulation with your JML Massager, there are a few things you can check: * If the soles of your feet are too dry, dampen them to increase conductivity. * Make sure your soles are correctly aligned on each foot plate. * Ensure gel pads are firmly attached to the skin and not overlapping. * Verify the electrode cord is correctly connected. * Increase the intensity using the intensity button.
M
Michelle RosarioAug 5, 2025
How to fix a JML circulation enhancer that will not turn on?
- C
  Christina TownsendAug 6, 2025
  If your JML Massager isn't turning on, here are a couple of things to check: 1. Make sure the batteries are inserted in the correct direction. 2. Verify that the adapter jack is properly connected to both the device and the wall socket.
W
wardkarlaAug 11, 2025
What to do if JML circulation enhancer power turns off during use?
- M
  Mr. Jordan WhiteAug 11, 2025
  If the power on your JML Massager turns off while you're using it, here are a few potential causes: * If using batteries, they may be weak or exhausted. Try fitting three new 1.5V alkaline batteries type C. * The 25-minute treatment period may be over, causing the power to turn off automatically. You can restart the treatment or turn off the massager. * If using a body massager, the cable may be damaged. Consider replacing the electrode cord.
J
Jorge WoodAug 16, 2025
Why does the skin turn red or feel irritated after using JML Massager?
- J
  jonathan32Aug 16, 2025
  If the skin turns red or feels irritated when using the JML Massager, it could be due to the gel pads. If the adhesive surface of gel pads is dirty or dry, wash the adhesive surface of gel pads carefully whilst unplugged from machine and leave to dry thoroughly. If the adhesive surface of the gel pads is damaged, replace the gel pads.
B
bradley89Aug 21, 2025
How to attach gel pad to the skin for JML circulation enhancer?
- C
  Christopher WeeksAug 21, 2025
  If you're having trouble attaching the gel pad to your skin when using the JML Massager, try these solutions: * Peel off the transparent film on the adhesive surface of the gel pad. * Allow your skin to dry if you've just washed it before applying the gel pad. * If the adhesive surface of the gel pad is damaged, replace it. * If the gel pads get dirty and lose their stickiness, replace the gel pad or clean the gel pad with a small drop of water rubbed onto the sticky side of the electrode pad.
D
Dwayne BrownAug 26, 2025
Why is the adhesive surface of my JML circulation enhancer Massager's gel pad sticky?
- C
  Christopher HammondAug 26, 2025
  If the adhesive surface of the gel pad on your JML Massager is sticky, it may be due to using the gel pad during perspiration. Try chilling the gel pad in a domestic fridge for 3-4 hours.