JML DriBUDDI - Assembling DriBuddi

5
Assembling DriBuddi
1. Insert the 3 (I) Dryer Legs into the
holes on the base of the (B) Motor Unit
(see Fig.1). Ensure they are all fitted
tightly and equally so there is stability.
For ease of installation and to prevent
damage to the motor unit, hold the
(B) Motor Unit upside-down on a soft
surface.
2. Place the (F) Lower Tube through the
(G) Waterproof Plate before screwing
onto the (B) Motor Unit until tight
(see Fig. 2).
3. Screw the (E) Clothes Hanger onto the
(F) Lower Tube until tight (see Fig. 3).
4. In a similar way to opening an
umbrella, push the top of the (E)
Clothes Hanger upwards until the
arms are fully horizontal and have
clicked into place (see Fig. 4).
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Your DriBuddi continued