EN
16
English
CLEANING AND STORAGE
-Product for food use.
-Before each use, as well as for the rst, clean the product with soap and water.
-Before cleaning, make sure that the device is turned o and disconnected from the mains.
-If you are going to clean it after using it, make sure it is cold before starting the cleaning.
-Do not use aggressive substances for cleaning, such as abrasive substances or other washing
agents, as otherwise they could damage the surfaces.
The motor base.
It cannot be immersed in water or any other liquid and is not dishwasher safe.
Clean it with a soft, slightly damp cloth.
Accessories.
They are all dishwasher safe.
Intensive cleaning program 1, to thoroughly clean the jar and lid you must select program 1 (see
automatic programs section).
Pour in 500 ml of water and 1 teaspoon of dishwashing detergent, then add a measuring cap of
100 ml of cleaning vinegar. Wait 20 minutes before emptying and washing the container. Let dry by
turning it upside down. Empty the carafe after each use. Leave a pause time between two programs
to allow the robot to cool down.
PROBLEM RESOLUTION
Problems found Causes Solutions
The robot does not turn on
is the plug connected to the
outlet?
Check if the device is connected to the ne-
twork. Plug the device into a mains socket
Is the back switch connected? Check that the rear switch is in the ON
position
Does the power outlet work
properly?
Check that the electrical outlet in your
home is working properly.
Code E03 ashes on the
screen
Is the Stainless Steel Measuring
Jug installed correctly?
Place the jug correctly see point PLACE
THE MEASURING JAR
Is the lid on the jar properly? Fit the cover correctly, see point FITTING
THE COVER
Presence of liquid under
or around the robot
Is the blade mounted correctly? Check that the blade is correctly mounted,
see point Removing/Installing the blades
Is the blade gasket in perfect
condition?
Check the blade gasket to make sure it is
not broken or torn, if it is, replace it
Is the lid mounted correctly? Check that the cover is correctly assem-
bled, see the point to t the cover
Is the cover gasket in perfect
condition?
Check the gasket of the lid to verify that it
is not torn or torn, if it is, replace it
Have you used the appliance at
speed 10?
Remember that if you use the appliance
at speed 10 lled to the 1,5 liter level and
without the measuring cap, there may be
splashes
TURBO function does
not work
is the jar temperature above
60°C?
Check temperature, wait for temperature to
drop below 60°C again
You can not put more than
speed 4
is the jar temperature above
60°C?
Check temperature, wait for temperature to
drop below 60°C again
To Next Page
Loading...
