Jocel JACP-010 - TROUBLE SHOOTING; Troubleshooting Guide

TROUBLE SHOOTING
Never try to repair or dismantle the air condition yourself. Incompetent repairs result in
loss of warranty and can endanger the user and the property.
Problem
Cause
Solution
The air conditioner
does not function
No power supply
Connect a functioning outlet
and switch on.
Is the power light flashing?
Empty the drain pan.
Timer function is active
Desactivate the TIMER
function.
The air conditioner
does not seem to
perform
The unit is in direct sunlight
Close curtains
Windows or doors open,
many people or a heat
source in the room
C
lose doors and windows,
place an extra air conditioner
The filter is dirty
Clean or replace the filter
Air inlet or air outlet blocked
Remove the blockage
Room temperature lower
than the selected value
Change temperature selection.
Set at the lowest possible
setting: 17ºC
The unit is noisy Unit stands unevem
Place on an even, solid
surface (less vibration)
The compressor
does not work
The overheat protection is
probably activated
Wait 3 minutes until the
temperature has decreased,
then turn on the unit again
The remote control
does not function
Distance too great
Remote control signal not
detected by the control panel
Make sure the remote control
is correctly aimed at the
control panel.
The batteries are drained
Replace the batteries
To correct problems that have not been described in the table and/or if the
recommended solutions fail to solve the problem, contact the Technical Assistance.
-36-