If the oven is to work properly, the kitchen housing must be suitable. The panels of the
kitchen unit that are next to the oven must be made of a heat resistant material. Ensure
that the glues of units that are made of veneered wood can withstand temperatures of
at least 120 ºC. Plastics or glues that cannot withstand such temperatures will melt and
deform the unit, once the oven has been lodged inside the units, electrical parts must
be completely insulated. This is a legal safety requirement. All guards must be firmly
fixed into place so that it is impossible to remove them without using special tools.
Remove the back of the kitchen unit to ensure an adequate current of air circulates
around the oven. The hob must have a rear gap of at least 45 mm.
DECLARATION OF COMPLIANCE
When you have unpacked the oven, make sure that it has not been damaged in any
way. If you have any doubts at all, do not use it: contact a professionally qualified
person. Keep packing materials such as plastic bags, polystyrene, or nails out of
the reach of children because these are dangerous to children.
To Next Page
Loading...
