Johannus MIDI Sequencer + - Troubleshooting Common Issues; Problem;Solution Chart

Issue 2.0W 12/12/2012 Church Organ World Sequencer Plus - User Manual Page 25 of 27
Troubleshooting Chart
Message/Problem Meaning/Cause Explanation
SD card not found There is no SD card in the SD
card slot.
Insert an SD card.
Card locked! You are trying to make a
recording on a write-protected
SD card.
The SD card has a slide. Put the slide in the unlocked
position.
Disk full! The SD card is full. Remove some MIDI les or insert an empty SD
card.
Read error The le cannot be read. Replace the le.
File not found The le does not exist or has a
faulty reference.
Remove the le or the faulty reference. (If the le
has been edited in Windows® then use command
mode to check that the lename complies with DOS
8.3 format, Longer lenames are allowed but only
8 characters can be displayed)
Maximum record
les
The maximum number of
record les has been reached.
The maximum is 99999. Rename or remove
existing recordings the names of which begin with
REC and/or reset Record Counter.
End of playlist You press play while the
playlist has reached the end
Go back to the beginning of the playlist using the
selector.
stop point You have selected a stop point
in the playlist and pressed
play.
Select a song.
New SD card found
reading
The MIDI sequencer is busy
reading the SD card. If the
reading takes more than a
few seconds, there may be a
contact problem
Wait until the MIDI sequencer is ready Switch
the MIDI sequencer off Remove the SD card and
again. Insert the SD card again. Switch the MIDI
sequencer ON
The stops on the
organ do not switch
on or the stops are
ashing
The connections MIDI IN and
MIDI OUT may have been
connected to the same device
and the MIDI Forward mode
is on. The le may have been
edited incorrectly.
Switch off the MID Forward mode.
Check any editing
You cannot find
certain MIDI les.
The MIDI sequencer may still
be in a playlist (the screen
shows PL).
Switch off the Playlist mode
During playing the
stops, the tempo
changes or the
general volume are
not working.
The stops/Instr. , Tempo and/
or Volume modes may be OFF.
The le may have been edited
incorrectly.
Set the mode involved to ON
Check edited les.
MIDI error more
than 39 tracks [Press
any Key]
Maximum number of tracks is
reached
MIDI sequencer does not support more than 39
tracks.