Issue 2.0W 12/12/2012 Church Organ World Sequencer Plus - User Manual Page 6 of 27
5. Installation
5.1. Connections
The connection points for the Sequencer are situated on the side together with the On/Off switch.
To connect the sequencer to another MIDI device
1. Ensure the power is switched off on the the sequencer and on the other MIDI device to be connected
2.
Connect the 9v connector to the sequencer and plug the associated mains adaptor into an electrical outlet.
3. Plug one end of the MIDI cables into the MIDI OUT socket and the other end of the cable into the the
MIDI IN socket of the other MIDI device.
4. Plug the other MIDI cable into the sequencer MIDI IN socket and its other end into the MIDI OUT
socket on the other MIDI device. Note that on Johannus and Makin organs MIDI OUT has been
changed to MIDI SEQ.
Warning
If you are connecting to a MIDI device that is not a Makin or Johannus organ. You are
strongly advised to consult the manual for that device before proceeding.
To Next Page
Loading...
Need help?
General