John Lewis Anna cot - Step 3: Set Mattress Base Height; Step 4: Adjust Dropside Runners

4
Step 3
Step 4
Part D
Part A
Fixing 4
Part A
The cot has a choice of three mattress base height positions. Screw four assembly dowels (fixing 4)
into lower, middle or upper mattress base position on the inside of the cot ends (part A). Note the
dropside is only functional when the mattress base is in its lowest position. The lowest base position
is the safest, and should be used as soon your baby is old enough to sit up. Drop mattress base
(part D) onto assembly dowels. Tighten the cams on front underside of mattress base using
a crosshead screwdriver.
Overhang should be
inside cot.
Part C
Adjust the wheel runners so that the dropside (part C) run smoothly. Drop side’s top
overhang should be inside cot.