Thank you for purchasing this product. Please read the instructions carefully before use to
ensure safe and satisfactory operation of this product. It is recommended that this product
should only be installed by persons competent in DIY. Before beginning assembly, please
ensure you have all parts outlined in the parts list below.
Assembly
You will need a power drill, 6mm masonry drill bit, medium cross-head screwdriver, tape
measure, spirit level and a pencil to install this product.
Ensure the wall surface is of suitable strength and construction.
Note: The wall plugs provided are suitable for solid stone or brick walls. For other wall types
(e.g hollow plasterboard) use appropriate wall plugs and drill bit.
To adjust angle of mirror, adjust length of screw hooks protruding from wall. Do not expose
threaded part of hook. To hang mirror vertically (ie ush to wall) refer to diagram A below.
To hang mirror at an angle refer to diagram B below.
If in doubt, consult a qualied person.
Parts list
Mirror
Wall hooks ( ×2)
Wall plugs (×2)
Material composition
Silver mirror
1
2
Ensure holes
are level
Locate mirror
over wall hooks
Mark hole
positions
Locate and mark centres using
mirror assembly as template
Wall plugs
Wall hooks
6mm drill
!
3
4
5
6
Spacer buttons
A B
To adjust angle of mirror
Do not expose
threaded
part of hook
X
HS10_RTL_280818
To Previous Page
Loading...
