DRCPX Remote Controller User Manual
9
4. Operation guide
1.
After putting through the power, press the ON/OFF button on the remote controller to
turn ON
the air conditioner.
2.
Press the MODE button to select the mode: AUTO, COOL, DRY, FAN,
or HEAT.
3.
Press
the UP or DOWN button to set the temperature. (Temperature cannot be adjusted
under auto mode.)
4.
Press the FAN button to set the fan speed: auto, low, medium, or high.
5.
Press the SWING button to select the louver angle of the fan.
5. Replacing the Remote Controller Batteries
1. Press the back side of remote controller marked
the cover of battery box along the arrow direction.
2.
Replace two 7# (AAA 1.5V) dry batteries, and
make sure the position of "+" polar and "-" polar
are correct.
3. Reinstall the cover of battery box.
NOTICE
● During operation, point the remote control signal sender at the receiving
w
indow on indoor unit.
● The distance between signal sender and receiving window should be no
more than 8m, and there should be no obstacles between them.
or wireless telephone; remote controller should be close to indoor unit during
o
peration.
● Replace new batteries of the same model when replacement is required.
● When you don’t use remote controller for a long time, please take out the
batteries.
● If the display on remote controller is fuzzy or there’s no display, pleas
e
replace batteries.
To Next Page
Loading...
Need help?
General