EasyManuals Logo

Johnson Controls HomeLink User Manual

Johnson Controls HomeLink
7 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #5 background imageLoading...
Page #5 background image
Rolling Code Synchronisation
Your vehicle must be within operating range of the gate or g
Your
vehicle
must
be
within
operating
range
of
the
gate
or
g
be switched on. Make sure you comply with the safety instr
u
rolling code.
1. Locate the training button (programming button) on th
unit. Exact location and colour of the button may vary
(refer to the operating instructions of the gate or gara
g
remote controls”).
2. Press the training button (programming button) on th
e
unit (which will usually activate a “training” light).
Note: Following step 2, there are typically 30 secon
d
3. Firmly press and release the programmed HomeLink
button a second time to complete the training proces
s
may
require you to do this procedure a third time to compl
e
The gate or garage door opener should now recognise the
H
HomeLink button is pressed.
The remaining two buttons may now be programmed if this
Please refer to Programming.
Reprogramming a Single HomeLink Button
If a HomeLink button has been programmed to activate a d
e
to operate a different device, proceed as follows. This proc
e
of the respective HomeLink button.
1. Press the appropriate HomeLink button
I, II, or III which you want to program
and keep holding it for about 20 seconds
until the diode starts flashing slowly (fig.6).
Do not release until step 4 has been
completed.
2.
When the diode begins to flash slowly (after
2.
When
the
diode
begins
to
flash
slowly
(after
approximately 20 seconds), hold the remote
control of the device you wish to train approx.
5-30 cm away from the HomeLink transmitter
unit - keeping the diode in view.
Johnson Controls5
garage door opener and the ignition should
garage
door
opener
and
the
ignition
should
u
ctions even when synchronising the
e gate or garage door opener motor head
by gate or garage door opener brand
g
e door opener “Training additional
e
gate or garage door opener motor head
d
s in which to initiate step 3.
button. Press and release the HomeLink
s
. (Some gate or garage door openers
e
te the training).
H
omeLink signal and activate when the
has not previously been done.
e
vice, and you now wish to use this button
e
dure will erase the existing programming
Fig. 6

Other manuals for Johnson Controls HomeLink

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Johnson Controls HomeLink and is the answer not in the manual?

Johnson Controls HomeLink Specifications

General IconGeneral
BrandJohnson Controls
ModelHomeLink
CategoryGarage Door Opener
LanguageEnglish