2 Network Room Modules Installation Guide
Canada
This Class (A) digital apparatus meets all the requirements of the Canadian
Interference-Causing Equipment Regulations.
Cet appareil numérique de la Classe (A) respecte toutes les exigences du
Règlement sur le matériel brouilleur du Canada.
Tools
• Flat-head screwdrivers, 3 mm and 5 mm (1/8 to 5/32 in.)
• Drill, bits, and appropriate 4 mm (3/16 in.) screws and plugs
• Pointed tool (available from Johnson Controls, Ordering Code TM-9100-8900
in Europe, or T-4000-119 in North America)
Figure 1: Dimensions, mm (in.)
(1) LCD Display with backlight
(2) Dial for temperature set point adjustment
(3) °C/°F Button
(feature available in specific models, see Ordering Codes)
(4) Fan button for fan speed adjustment
(feature available in specific models, see Ordering Codes)
(5) Service port
(6) Display in Celsius and Fahrenheit units
Mounting
The NRM mounts directly on a wall surface in the room you want to control.
Choose a location for the NRM while considering the following information:
• Place the room module where the occupant can easily read the LCD and
use the controls.
• Place the module where the ambient temperature is representative of the
general room conditions if you want to use the built-in temperature
sensor to measure space temperature. For example, there should be a
sufficient amount of air circulation.
• Avoid cold or warm air drafts, radiant heat, and direct sunlight.
• Place some insulating material in the wiring access hole or conduit to
prevent the introduction of air from outside the room.
To Next Page
Loading...
Need help?
General
