Johnson Controls M9216 Series

To Next Page

Installation Instructions M9216

Issue Date October 2017

Part No. 34-636-461, Rev. J www.johnsoncontrols.com

M9216 Series Electric Spring Return Actuators

Installation

IMPORTANT: The M9216 Series actuator is

intended to control equipment under normal

operating conditions. Where failure or malfunction of

an M9216 actuator could lead to an abnormal

operating condition that could cause personal injury

or damage to the equipment or other property, other

devices (limit or safety controls) or systems (alarm or

supervisory) intended to warn of, or protect against,

failure or malfunction of an M9216 actuator must be

incorporated into and maintained as part of the

control system.

Parts Included

• M9216 actuator

• M9000-100 NPT conduit adaptor and nut

(two included for actuators with switches or a

feedback potentiometer)

• M9000-160 anti-rotation bracket

• two No. 12-24 x 1/2 in. self-tapping hex

washer-head screws

• 5 mm manual crank

For GGA models:

• one M9000-106 pluggable 4-terminal block

For GGC models:

• two M9000-105 pluggable 3-terminal blocks

• one M9000-106 pluggable 4-terminal block

Special Tools Needed

• Drill with a 3/16 in. (No. 15, 4.57 mm) drill bit

• Torque wrench with 10 mm socket

• 7 mm and 5/16 in. (8 mm) nut driver

• Digital voltmeter

Spring Return Direction

The actuator is factory set to spring return in a

Counterclockwise (CCW) direction.

Clockwise (CW)

To change the spring return direction to CW, refer to

Figure 1 and proceed as follows:

1. Turn the actuator over. Use a flat-blade

screwdriver to release the locking clip, and remove

it from the coupler.

2. Remove the coupler and sleeve from the front of

the actuator, and slide the sleeve off the coupler.

Groove

for the

Locking Clip

Locking

Clip

Limit

Stop

Position

Indicator

Tab

Back of

the Actuator

Sleeve

Figure 1: Changing the Spring Return Direction

*34636461G*

34-636-461, Rev. J

Main Page

Need help?

Do you have a question about the Johnson Controls M9216 Series and is the answer not in the manual?

Johnson Controls M9216 Series Specifications

General

Input Voltage	24 VAC/DC
Supply Voltage	24 VAC/DC
Communication Protocol	BACnet MS/TP
Agency Listings	UL, CE
Temperature Range	-40°C to 70°C
Operating Temperature	-40°C to 70°C
Storage Temperature	-40°C to 85°C
Humidity	10% to 95% RH (non-condensing)
Humidity Range	10% to 95% RH (non-condensing)