6
KP-241 PG2 – Installation Instructions
Operating the keypad
Table 3: Quick reference guide
Arms the system to protect the site perimeter. Movement
within the interior does not trigger an alarm.
Press the Arm Home button and enter
your user code or present your tag.
Arms the system when you vacate the protected site.
Press the Arm Away button and enter your
user code or present your tag.
Arms the system without the need to provide a user code.
Note: Enable Quick Arm on the control panel to use this
function.
Press and hold the Arm Home button for
two seconds
Arms the system without the need to provide a user code.
Note: Enable Quick Arm on the control panel to use this
function.
Press and hold the Arm Away button for
two seconds.
Arms away and enables an automatic latchkey message to one
or more designated phone numbers, or to the user app, when a
latchkey user disarms the system. For example, parents can use
this feature to receive a notification when a child has returned
home and disarmed the system. You can assign latchkey users
to users 5 to 8.
Press the Arm Away button three times.
Use this feature to skip the entry delay time period after you
arm the system.
A detection in any zone will trigger an immediate alarm.
Press the Arm Home or Arm Away button,
enter your user code or present your tag,
and then press the Arm Instant button.
Restores the system to the standby state.
Press the Disarm button and enter your
user code or present your tag.
Initiates a silent alarm if you need to disarm the system under
duress.
The system disarms normally, but a silent alarm transmits to
the monitoring station.
Press the Disarm button and enter the
duress code. The default duress code is
2580.
Initiates an emergency alarm.
Press and hold the Emergency button for
two seconds
Press and hold the Fire button for two
seconds.
Press and hold both the Emergency and
Fire buttons for two seconds.
Use the partition feature to arm and disarm up to three
controllable areas.
Note: Enable partitioning on the control panel to use this
feature.
Press Partition buttons 1, 2 or 3 to select a
partition before arming or disarming the
system.
Activates the function set by the installer. Please refer to
Table
2
.
Press the Function button.
To Next Page
Loading...
Need help?
General
