Johnson Controls YORK RSR-4445 - TABLE 18 - Torque Values for Model 16799 Compressor

JOHNSON CONTROLS
36
FORM 50.40-OM1 (713)
ISSUE DATE: 07/17/2013
SECTION 5 - REPLACEMENT PARTS AND KITS
7. Make sure that the synthetic rubber seat ring is
tight against the shoulder of the oating seat,
with rounded outer edge at the rear to facilitate
insertion. The ring is assembled this way when
shipped. See that there is a 1/32” (0.79 mm) mini-
mum radius (do not chamfer) on the edge of the
cavitywhichholdstheoatingseatandseatring.
Oil the outer surface of the seat ring with refrig-
eration oil, and push the assembly into the cavity
seatingitrmlyandsquarely.
8. Slide end plate on shaft and press it in as far as
it will go. Do not allow it to spring out or move
backward. Tighten screws or bolts uniformly to
keep the face of the seat at right angles to shaft.
Tightening of end plate automatically sets seal in
proper position. Be sure to use the torque require-
mentspeciedforthesealassembly. (SeeTable
18 on page 36)
After seal installation is completed, rotate
the compressor by hand several times to
help seat the seal mating surface.
TABLE 18 - TORQUE VALUES FOR MODEL 16799
COMPRESSOR
DESCRIPTION
TORQUE
FT. LBS. KM
Head 25 – 30 3.4 – 4.1
Clamping Stud 32 – 35 4.4 – 4.8
Cylinder to Crankcase 25 – 30 3.4 – 4.1
Shaft End Plate 9 – 15 1.2 – 2.1
Seal End Plate 9 – 15 1.2 – 2.1