4 ©2011 Johnson Level & Tool - Rev. 1
4. Operating Instructions
Battery Installation
1. Make sure the instrument is turned off.
2. Turn the battery compartment cover screw counter-clockwise
to remove the cover. Remove the old batteries, and install the
new batteries.
3. Turn on the level to see if all functions are correct.
Note:
1. Be sure to match up polarities when replacing the batteries.
2. Always remove the batteries before storing the instrument.
IMPORTANT: It is the responsibility of the user to verify the
calibration of the instrument before each use.
4595H-English_Manuals 4/8/11 9:31 AM Page 4
To Next Page
Loading...
