Johnson AE Series - Page 15

901-10113 - 15 - 9/16/2024
Turn On System
At the HOME screen, the F4 button is the
ON-OFF SWITCH. If Switch Status is OFF,
press F4 to turn ON the cooling system.
When Switch Status is OFF, the blinking
yellow indicator is a reminder that the
system is not cooling.
Turn the Switch OFF before unplugging
from AC power.
Run System
When Switch Status is ON, if the Cold
Plates are not frozen, the refrigeration
compressor runs to freeze the solution in
the Cold Plates and cool the body.
The blue indicator shows that the system
is actively cooling.
*In the event of a power outage, the
Switch remains at its previous setting. If it
was ON, it will still be ON when power is
restored.
Time to Pre-Cool a cold system.
(After use on route)
Usually 8 hours
Time to Pre-Cool a warm system.
(After out-of-service or defrost)
Usually 24 hours
Pre-Cooling
Completed
Once the Cold Plates are frozen, the
refrigeration compressor turns off.
The blue indicator goes away, because the
compressor is not running.
*ANTI SHORT-CYCLE DELAY is a temporary
message that the compressor will not
immediately re-start for a short time
(usually 30 seconds) even if conditions call
for additional cooling.
The green indicator shows that the
Cold Plates are fully frozen, and the
Interior Temperature is in the desired
range.