57
cooling mode.
For maximum safety, periodically check the condition of the power cable; if it is
damaged by use, for replacement, contact the JOHNSON Appliances Authorized
Technical Assistance Center.
ADVICE FOR MAXIMUM COMFORT AND MINIMUM CONSUMPTION
TO VERIFY:
That the unit delivery and suction grilles are always free;
the air filters are always clean, a dirty filter decreases the passage of air and reduces the
performance of the unit;
doors and windows are closed to prevent the infiltration of non-conditioned air;
the hose is correctly positioned, without kinks or bends that are too tight.
TABLE OF PROBLEMS
Check the appliance and the suggestions given here before contacting an authorized
technical assistance center. NEVER DISASSEMBLE or REPAIR the appliance by yourself as
it could cause damage to people, things or animals.
Cause
The appliance
does not start
Problems
Solution
Mancanza di alimentazione
Full water container
and relative indicator light
Ambient temperature too
low or too high
The room temperature is
lower than the set tempe-
rature in cooling mode
Connect the appliance to a working
power outlet and turn it on.
Drain the water stored in the ap-
pliance.
It is recommended to use this ap-
pliance between 5-35ºC
Change the set temperature
Bad
cooling down
Clean or replace the filters
Excessive exposure to
sunlight
The doors and windows are
open, the room is crowded
or there are other sources
of heat
Obstructed air inlet or
outlet
High level
of noise
The device is positioned on
an uneven, uneven surface
Place the device on a flat and sta-
ble surface (it can reduce noise)
The compressor
it does not work
Starting the overheating
protection
Wait 3 minutes until the tempera-
ture decreases, the appliance will
restart automatically
Close the door and window, remo-
ve other heat sources
Dirty filters
Remove any obstruction
To Next Page
Loading...
