58
Note:
Do not disassemble or repair the unit, improper repairs will void the warranty and can
cause damage to people, things and animals.
If the problem is not listed in the table, contact an authorized JOHNON Appliances
service center.
Ambient temperature sen-
sor failure
Pipe temperature sensor
failure
Frost protection
Is displayed
the code “E1”
Contact authorized technical assi-
stance center
Contact authorized technical assi-
stance center
The functions will be restored auto-
matically once the frost protection
has finished
Is displayed
the code “E2”
Is displayed
the code “E4”
The water in the com-
partmentof the appliance
is full
Drain the water
Fill indicator
water
The remote con-
trol it does not
work
It is too far away
The remote control does
not point to the receiver of
the device
Move the remote control closer to
the air conditioner and make sure
that the signal reaches the receiver.
The batteries are exhau-
sted
Replace the batteries
(LWA)
NPL-07CR
2.0kW
R290/125g
760W
300m /h
64dB(A)
PORTABLE AIR CONDITIONER
850W/3.8A
3.3GWP
2.0/2.6MPa
340*300*694mm
To Next Page
Loading...
