joke Multimaster - Operation and Use; Switching Device On and Off; Setting Oscillation Frequency

12 pages

To Next Page

To Previous Page

Operation/Use

JOKE

Instruction Manual Multimaster Grinding and Polishing System 7

Device overview

Figure 5.1 Device overview

1 ON/OFF switch

2 Speed control

3 Tool reception

Switching the device on and off

First check cable and plug for integrity.

Switching on

Move switch (5.1/1) to the front (I)

Switching off

Move switch (5.1/1) to the rear (0)

Setting oscillation frequency

Select oscillation frequency while the motor is running.

Select the optimum oscillation frequency depending on the acces-

sories and application with the speed control (5.1/2) .