12
CHAIN SHARPENING
Chain sharpening is a complicated task that
requires special tools. We recommend that
you refer chain sharpening to a professional
chain sharpener.
IGNITION TIMING
Ignition timing is fixed and nonadjustable.
SPARK PLUG
Replace the spark plug yearly using a Cham-
pion RCJ--7Y. Gap to 0,5 mm.
STORAGE
WARNING
:
Stop engine and allow to
cool, and secure the unit before storing or
transporting in a vehicle. Store unit and fuel
in an area where fuel vapors cannot reach
sparks or open flames from water heaters,
electric motors or switches, furnaces, etc.
Store unit with all guards in place. Position so
that any sharp object cannot accidentally
cause injury to passersby. Store the unit out
of reach of children.
S
Before storing, drain all fuel from the unit.
Start engine and allow to run until it stops.
S
Clean the unit before storing. Pay particu-
lar attention to the air intake area, keeping
it free of debris. Use a mild detergent and
sponge to clean the plastic surfaces.
S
Do not store the unit or fuel in a closed area
where fuel vapors can reach sparks or an
open flame from hot water heaters, electric
motors or switches, furnaces, etc.
S
Store in a dry area out of the reach of chil-
dren.
CAUTION
:
It is important to prevent
gum deposits from forming in essential fuel
system parts such as the carburetor, fuel fil-
ter, fuel hose, or fuel tank during storage. Al-
cohol blended fuels (called gasohol or using
ethanol or methanol) can attract moisture
which leads to fuel mixture separation and
formation of acids during storage. Acidic gas
can damage the engine.
DECLARATION OF CONFORMITY
relating to 2000/14/EC
EU Declaration of Conformity relating to 2000/14/EC
We,
Poulan/Weed Eater, Division Electrolux North America, Inc.,
Texarkana, TX,
75501, USA, Tél. : +1 903 223 4100, declare under sole responsibility that the
Jonsered
model 2035 chain saw
was assessed in accordance with Annex V of the DIRECTIVE and
from serial numbers 2001--305(N or D)00001 and onwards, conforms to the provisions of
the DIRECTIVE. The net power is 1,57 kW. The measured sound power is 114 dB and
the guaranteed sound power is 118 dB.
Texarkana 01--12--17
Michael S. Bounds, Director
Product Safety and Standards
DECLARATION OF CONFORMITY
relating to 89/392/EEC
Michael S. Bounds, Director
Safety and Standards
EU declaration of conformity
(Directive 89/392/EEC, Annex II, A) (Only applies to
Europe)
We,
Poulan/Weed Eater, Division Electrolux North America, Inc.
, Texarkana, TX
75501, USA, Tel: +1 903 223 4100, declare under sole responsibility that
Jonsered
model 2035 chain saw
from serial numbers 2001--305(N or D)00001 and onwards,
follows the provisions of the DIRECTIVES:
89/392/EEC
(machinery) and
89/336/EEC
(electromagnetic compatibility), including amendments and is in conformity with the
following standards:
EN 292--2, EN 608 and CISPR 12.
The supplied Chain Saw conforms with the sample that underwent the EU type
approval.
Notified body, 0404 the Swedish Machinery Testing Institute
, Fyrisborgsgatan 3
S--754 50 Uppsala, Sweden, has carried out EU type approval. The certificate(s) are
numbered:
404/98/597.
Texarkana 01--12--17
To Next Page
Loading...