Jonsered 2054 Workshop Manual

13
Safety equipment
1
Checking of the brake
effect
Start the engine.
Hold the handle with both hands and rev
up.
Release the chain brake by turning the
left wrist towards the hand guard without
releasing the grip round the front handle.
The chain should stop immediately.
Chain catcher
Replace the chain catcher if it is deformed
or cracked.
Checking of the brake
effect
Place the saw on a stable surface and
start the engine.
Hold the handle with both hands and rev
up.
Release the chain brake by turning the
left wrist towards the hand guard without
releasing the grip round the front handle.
The chain should stop immediately.
Chain catcher
The chain catcher has the purpose of
catching the chain if it breaks.
It is therefore important that it is not
deformed or cracked. Replace if this
should be the case.
Throttle lock
Dismantling
Remove the screws.
Remove the handle half, throttle control
and lock.
Throttle lock
Dismantling
Remove the screws which hold the handle
halves together and where appropriate
also the screw which holds the spring for
the vibration damper.
Lift off the handle half and throttle control
together with the lock.

Jonsered 2054 Specifications

General

Brand	Jonsered
Model	2054
Category	Chainsaw
Language	English