62
5
min. 1 mm
Centrifugal clutch
Remove the clutch springs with a small
screwdriver.
Clean and inspect the clutch parts for
damage and wear.
Inspect the chain gear and clutch drum’s
splines for damage.
Replace damaged parts.
Fitting mod. 630/670
Mod. 2095
Fit the clutch shoes.
Fit the springs from the back of the clutch.
Remove the clutch springs with a small
screwdriver.
Clean and inspect the clutch hub’s spokes
and clutch shoes for damage.
There must be a thickness of at least 1
mm left at the most worn place on the
clutch shoes.
All the shoes must be replaced at the
same time.
Lift off the plastic washer (mod. 630/670)
and inspect the chain gear and clutch
drum splines for damage.
The clutch drum’s inner diameter must
not exceed 79.8 mm.
Replace damaged parts.
Fitting mod. 630/670
Mod. 2095
Fit the clutch shoes on the hub.
Fit the springs from the back of the clutch
by pressing them in place with your thumbs
or with a screwdriver.
To Next Page
Loading...
